The garage door is an important part of your house but unfortunately, it is left unattended whenever a home improvement project is undertaken. Hence homeowners might face troubles of garage doors including jammed, rough movements of garage door, garage door not staying open or unwarranted opening of a garage door. There are plenty of garage doors services such as, Pro Garage Door Tulsa that can help you to keep your garage door functional forever.
As far as stuck garage door movements are concerned, it is normally because of the dented or deformed tracks of the garage door on which the garage door slides. Don’t worry they can be fixed easily without any hassle. Normally, with the help of a simple toolkit and a plastic hammer, you can tighten the dented tracks. A simple wrench can be used to tighten the screw and bolts. The rough opening and closing of the garage door might be due to the malfunction opener or remote control. There might be some problem with the circuit system of the garage door opener that can be fixed easily. Some problems happen when the main parts of the opener get defective, for example, the broken gears of the garage door opener. In such situations, professional repair work is needed. Hopefully, the following mentioned procedures will be useful for fixing and replacing the gears of your opener.
You can identify if the gears have been broken even though the motor is functioning properly and the torsion springs are in a good working position. These gears are made of plastic and are the weakest parts among the garage door opener components. They can be damaged easily due to several reasons like old age, dust, prolonged usages without garage door maintenance, imbalance movements of garage door, or might be due to manufacturing faults. But with the help of simple equipment and technical expertise, you can change the garage door gears on your own.
- First of all, you should disconnect the electric supply to the garage door to avoid the chances of injuries or electrocution and no one can operate the garage door when you are working on the garage door.
- Next, close the garage door by hand and remove it from pulley to make sure that garage door does not accidentally hurt you while working on it. Now you are ready to do work on opener to replace the gears.
- Now open the retainer cap of the belt pulley and then remove the sprocket. Now it is a time to remove the belt or chain from sprocket. Don’t forget to mark its position and tape it to avoid it from getting twisted and messy. Remove the end covers, the retaining clip, drive gear, and the RPM sensors. Disconnect the motor.
- For the assembly of nuts that hold the motor to the shaft. Remove the nuts first. Once you have released the motor from drive shaft, you can remove and replace the gears. After replacing the gears, you will have to reassemble the whole structure in a right order. Take care to make sure that each component goes into right position to avoid further issues.
Thus, you have experienced that replacing the damaged gears is a little bit challenging. Hence, if you are not sure about your capabilities, you should call a professional garage door repair expert to handle the matter.